60 cm LED TL 10W T8 Daylight 860

 16.95  12.95


LED TL 60cm 860 Daylight with an output of 120 lumens per watt. This is three times as much as a conventional fluorescent tube.

  • Until 30 days return right
  • Professional relief
  • 1 – 2 days delivery time
  • Delivery costs € 6.05 - € 6.95
    Free shipping for orders over € 50
Guaranteed safe checkout


Many people do not know that it is possible, but even fluorescent tubes have been replaceable for years LED fluorescent tubes. You can see our latest model here.

This fourth generation is equipped with SMD LEDs. After years of experience we can confirm that this LEDs not only have the highest efficiency and most beautiful light color, but are also the most reliable.

SMD LEDs have been used for decades in, for example, digital radio alarm clocks that provide light 24 hours a day. They have more than proven themselves when it comes to lifespan. These LEDs have only been available with normal light colors for a few years.

In YARLED TL version we have applied the very latest SMD LEDs & our new electronics with an efficiency of more than 110 lumen per watt. This is more than twice as much as a conventional one Fluorescent tube.

LED TL you save more than 60% in energy without noticeable difference in light output. Another advantage is the longer service life.
A normal one Fluorescent tube only lasts 10,000 hours in practice, one LED fluorescent tube at least 50,000 hours. In addition to the substantial savings on the energy bill, you also save considerably on replacement costs with LED TL. That is why your regular fluorescent tubes have been replaced by LED fluorescent tubes a very attractive investment that, in most cases, pays for itself within 2 years and then provides another 20 years of financial benefit.

What makes our LED TL so unique:

For example, we have a heat-conducting double-walled aluminum frame as a basis that dissipates the heat produced by the LEDs through the rear of the tube.

You often see at LED TL that the LEDs are completely enclosed in a glass tube; the LEDs cannot lose their heat properly and will break down much faster. That is not the case at YARLED. Ours also have LED TL a frosted glass acrylic cover, so that the light is nicely distributed and the LEDs are not visible. This new cover ensures that the switched on LED fluorescent tube looks exactly the same from a distance as a normal one LED TL. You will not see the difference! The ends are made of extra strong plastic so that these tubes are extra durable and during possible
transport cannot be damaged.

How to install:

  • Do you have a fixture with a starter?
    Remove the starter and replace it with the supplied LED starter and LED tl. Ready (see shema)
  • Pay attention!
    If the fluorescent fixture uses a high-frequency ballast, remove it from the circuit and connect it as shown below on one side.

With LED starter:

With LED starter

Without starter a high-frequency ballast:

LED fluorescent diagram


Additional information




Similar to:

Luminous flux (Lumen)

Color display Led Kelvin

Color rendering Ra (CRI)

Dimensions in mm (incl. Fitting)


Radiation angle

Labor or Power factor

IP Code


Brand of the LEDs


Minimum service life

Quality mark

Additional information